Operating Instructions; Remote Control; Setting Up The Mover - Truma Mover smart A Gebrauchsanweisung

Operating instructions

Remote control

Mover
smart A
1
2
10
9 3
8 4
5
7
6
Mover
smart
Figure 2
1 Move the caravan forward
2
Engage the Mover (only Mover smart A)
3 Rotate the caravan clockwise (via right axle)
4 Switch off (red) / emergency off switch
5 Rotate the caravan anti-clockwise (via right axle)
6 Move the caravan backwards
7
Rotate the caravan clockwise (via left axle)
8 Switch on (green)
9 Rotate the caravan anti-clockwise (via left axle)
10 Disengage the Mover (only Mover smart A)

Setting up the Mover

Prior to using the Mover, observe the
"Safety instructions"!
– Establish the Mover power supply via the battery cut-off
switch.
– If the caravan is disengaged (apply the parking brake or
secure against rolling away), engage the mover.
Mover
smart M
1
9 3
8 4
5
7
6
Mover
smart
Engaging Mover smart A
– Switch on remote control. (See "Switching on the remote
control")
– Press the button (Figure 3 - 2) on the remote control for
approx. 5 sec. and then release. The drive roller is engaging.
The indicator (Figure 3 - 1) flashes during the process.
Only after the indicator on the remote control stops
flashing, the process is complete and the remote control
can send new commands.
Figure 3
Engaging Mover smart M
– Insert the engagement key onto the toggle crank.
Figure 4
– Tighten the engagement key in the direction of the tyre
until the drive roller is positioned on the tyre and the
position indicator in the housing shows "√". In the end
position, the drive unit securely engages. This is to be
checked on both sides prior to manoeuvring.
Figure 5
– Removing the engagement key
The drive roller must be firmly positioned on both wheels.
1
2
2
1
1
EN 13