Inspections; Disposal; Troubleshooting Guide - Truma Mover smart A Gebrauchsanweisung

Inspections

– Regularly check the installation, wiring and connections
for damage. The drive units must be able to move freely
and during disengagement automatically be drawn back
by the return springs to the safe rest position. If this is not
the case, inspect the drive units for dirt or corrosion on
the guides and, if necessary, have them cleaned by trained
specialist staff.
– Following the annual inspection, check whether all motors
respond properly to the commands of the remote control.
– At least every two years, the Mover must be inspected
by a trained specialist for rush, secure positioning of
attachment parts as well as the proper condition of all
safety-related parts.

Disposal

The appliance must be disposed of according to the
administrative regulations of the respective country in which it
is used. National regulations and rules must be followed.
EN
16

Troubleshooting guide

Fault Cause and remedy
Mover is not – Check the power supply (the
working green LED on the control unit
should light up). A faulty fuse in
the Mover's battery connector
cable may be replaced only by an
original Truma spare part (part no.
60040-00169)
– Interrupt the power supply for at
least 20 seconds. Re-establish the
power supply. The green LED on
the control unit should light up.
Mover is not Control unit has overheated.
functioning and
the red LED on
– Interrupt the power supply
the control unit with the battery cut-off switch
is flashing and remove the key. Let the
control unit cool down for at
least 20 minutes. Then start up
the Mover.
Mover is not
Low battery in the remote control -
responding or only red LEDs on the remote control are
with interruptions flashing.
to the remote
control input – Check battery and battery
contacts of the remote control.
Replace battery or clean battery
contacts, if necessary.
Low battery of the Mover - green
LED on the control unit is flashing.
– Check the battery of the Mover.
Charge or replace the battery,
if required.
Drive roller slides
– Check tyre pressure and adjust,
down on the if necessary.
wheel
– Check tyre profile and change
tyres, if necessary.
– Disengage Mover and measure
the distance between the tyres
and drive roller. The distance
should be 20 mm.
The Mover does – When disengaging the Mover,
not engage on ensure that the power supply
one side (only is not interrupted or the remote
Mover smart A)
control is not switched off. Only
after the indicator on the remote
control stops flashing, the process
is complete.
– Manually engage the Mover with
the socket wrench by approx. two
clockwise resolutions. Then try
engaging the Mover once again.
The Mover does – Manually disengage the Mover
not disengage (see "Disengaging Mover smart A"
(only Mover on page 14)
smart A)