Switching Off The Remote Control (Emergency Off); Interrupting The Power Supply; Battery Replacement In The Remote Control; Disposal Of The Remote Control And Batteries - Truma Mover smart A Gebrauchsanweisung

Disengaging Mover smart M
Figure 9
– Insert the engagement key onto the toggle crank.
– Turn the engagement key in the opposite direction to
the tyre until the drive roller securely engages in the end
position. The position indicator in the housing is now set
to "X" (Figure 10 - 1).
Figure 10
– Removing the engagement key.
Switching off the remote control
(emergency off)
Switching off the remote control immediately stops any
running processes (such as engagement and
manoeuvring). Once the remote control is switched back on,
these functions can be re-activated.
The remote control switches off after approx. 3 minutes
of idle time.
– Press the button (Figure 2 - 4) on the remote control.
The LED lighting goes out.

Interrupting the power supply

Following each use of the Mover, disconnect the Mover power
supply at the battery cut-off switch and remove the key.
The key for the battery cut-off switch must be stored in
a place inaccessible to children.
1
2
1

Battery replacement in the remote control

Only use leak-proof 9 V batteries (MN 1604).
The red LEDs on the remote control flash if the battery
power is too low.
– Unscrew the screw on the back of the remote control and
remove the battery cover.
Figure 11
– Replace the battery (ensure correct polarity) and then screw
the battery cover back on.
Empty, used batteries can leak and damage the remote
control. Remove the batteries if the remote control is not
being used for an extended period of time.
No warranty for damage caused by leaking batteries.

Disposal of the remote control and batteries

The remote control and batteries must not be disposed
of with household waste but separately via a recycling
collection point. In doing so, you are contributing
towards re-use and recycling efforts.

Maintenance

Prior to cleaning, disconnect the power supply of the
Mover via the battery cut-off switch.
Keep the drive elements free from coarse dirt. When cleaning
the caravan, clean the Mover with a damp cloth in order to
loosen mud etc. Make sure that no stones, twigs etc. are
trapped in it. Clean the drive rollers with a hard brush.
The control unit does not require maintenance. Keep the
remote control in a dry place.
Clean the Mover on an annual basis (or before overwintering)
as described above.
Do not park the caravan with the drive rollers engaged.
In the case of a longer downtime, the battery must be
disconnected and charged in the meantime (see Battery care).
Charge the caravan battery prior to start-up.
You or your caravan dealer can easily check or maintain
your Mover every year during the annual inspection of your
caravan. If you have any doubts, please contact Truma
Service (www.truma.com).
EN 15