Jumper Settings - Exsys EX-1517HMVS Anleitung

English
3. Layout, Connections & Jumper Settings
3.2 Connections
USB 3.2 (Gen1) A-Port:
StdB_SSTX +
StdB_SSTX -
VCC
USB 3.2 (Gen1) B-Port:
StdB_SSTX +
StdB_SSTX -
D-
D+

3.3 Jumper Settings

The EX-1517HMVS will be delivered with the setting Bus-Power.
possibility to cut the power at the data line.
screws on both sides. Then you must set the jumper JP2 from ENA (Enable) to DIS
(Disable). See the following picture.
© Copyright 2020 by EXSYS Vertriebs GmbH. All Rights Reserved
GND_DRAIN
StdB_SSTX+
StdB_SSTX -
GND
D- D+
GND_DRAIN
StdB_SSTX+
StdB_SSTX -
VBus
GND
ENA
DIS
Attention!
Never plug in with force
or in wrong direction.
Attention!
Never plug in with force
or in wrong direction.
For this you open the case with the four
JP2
12
EX-1517HMVS
But you have the