Additional Special Safety Instructions For Abrasive Cutting - Parkside PWS 125 F5 Originalbetriebsanleitung

Additional special safety instructions
for abrasive cutting
a) Avoid any blockage to the cutting disc or
excessive contact pressure. Do not make any
excessively deep cuts. Overloading the cutting
disc increases the stress and likelihood of jam-
ming or blocking and thus the possibility of a
kickback or a breakage of the grinding tool.
b) Avoid the area in front of and behind the
rotating cutting disc. When you move the cut-
ting disc away from yourself in the workpiece,
it is possible, in the event of a kickback, that
the electrical tool will be thrown out directly
towards you together with the rotating disc.
b) If the cutting disc jams or you stop working,
switch the tool off and hold it steadily in
the workpiece until the disc has completely
stopped turning. Never attempt to pull a ro-
tating cutting disc out of a cut. This could lead
to a kickback. Identify and remove the cause of
the jam.
d) Do not switch the power tool back on while
it is located in the workpiece. Allow the cut-
ting disc to reach its full speed before you
carefully continue the cut. Otherwise, the disc
can jam, jump out of the workpiece or cause a
kickback.
e) Support boards or large workpieces to re-
duce the risk of the cutting disc jamming and
causing a kickback. Large workpieces can
bend under their own weight. The workpiece
must be supported on both sides of the disc:
both in the vicinity of the cutting disc and also
at the edge.
f) Be particularly careful when making pocket
cuts into existing walls or other obscured areas.
The inserted cutting disc may cut into gas or
water pipes, electrical wiring or other objects
that can cause a kickback.
│ GB │ MT
■ 56 PWS 125 F5