Outdoor Unit Installation - Kaisai KFS-50 HRFI Bedienungsanleitung

Outdoor Unit Installation

Outdoor Unit Installation Instructions
Step 1: Select installation location.
The outdoor unit should be installed in the
location that meets the following requirements:
Place the outdoor unit as close to the indoor
√

unit as possible.
Ensure that there is enough room for
√

installation and maintenance.
The air inlet and outlet must not be
√

obstructed or exposed to strong wind.
Ensure the location of the unit will not be
√

subject to snowdrifts, accumulation of leaves
or other seasonal debris. If possible, provide
an awning for the unit. Ensure the awning
does not obstruct air ow.
The installation area must be dry and well
√

ventilated.
There must be enough room to install the
√

connecting pipes and cables and to access
them for maintenance.
Strong wind
Fig. 9.1
Step 2: Install outdoor unit.
Fix the outdoor unit with anchor bolts (M10)
>60cm / 23.6"
Fig. 9.3
Strong wind
Fix with bolts
The area must be free of combustible gases
√

and chemicals.
The pipe length between the outdoor and
√

indoor unit may not exceed the maximum
allowable pipe length.
If possible, DO NOT install the unit where it
√

is exposed to direct sunlight.
If possible, make sure the unit is located far
√

away from your neighbors' property so that
the noise from the unit will not disturb them.
If the location is exposed to strong winds (for
√

example: near a seaside), the unit must be
placed against the wall to shelter it from the
wind. If necessary, use an awning.
(See Fig. 9.1 & 9.2)
Install the indoor and outdoor units, cables
√

and wires at least 1 meter from televisions or
radios to prevent static or image distortion.
Depending on the radio waves, a 1 meter
distance may not be enough to eliminate all
interference.
Fig. 9.2
CAUTION
Be sure to remove any obstacles
•
that may block air circulation.
Make sure you refer to Length
•
Speci cations to ensure there is
enough room for installation and
maintenance.
92
9
Strong wind