Power On/Off; Quick Reference Guide - Huntleigh Smartsigns LITE Serie Kurzes Handbuch

HEALTHCARE

Quick Reference Guide

This guide is intended as a quick reference for experienced users. All users
should review and understand the full operating instructions as detailed in this

Power ON/OFF

1. Locate the black power switch on the back surface near the top right
(as viewed from the front of the device).
Blood Pressure Operation
1. Turn device on, or press C C L L E E A A R R to clear memory between patients.
2. Attach correct size of cuff to the upper arm of the patient.
Press C C Y Y C C L L E E to select a cycle time of 1, 2, 3, 4 or 5 minutes (Automatic
3.
Mode) or SP (Manual Mode).
4. Press N N I I B B P P S S T T A A R R T T to initiate the blood pressure measurements.
5. Press S S T T O O P P at any time to pause the measurements.
6. Press R R E E V V I I E E W W to scroll through previous readings and average (the first
reading is automatically discarded from the average).
Temperature Operation
1. Connect appropriate temperature probe to device: blue for oral and
axillary, red for rectal.
2. Press temperature M M O O D D E E to select: single/oral, single/axillary,
continuous/oral, or continuous/axillary (Smartsigns® LITE Series will
automatically go into continuous mode for rectal measurements).
3. Withdraw probe from the probe holder and insert into a new disposable
probe cover.
4. Press temperature S S T T A A R R T T to initiate measurement.
5. Place and hold the temperature probe in correct position as described in
the manual.
6. In single measurement mode, a tone will sound and the results are
displayed after 15 seconds.
7. In Continuous Mode, wait 4 minutes before recording the measurement,
and then press temperature S S T T A A R R T T to complete the continuous
measurement.
8. Discard the used probe cover and place the temperature probe into
probe holder.
User Manual.
(use the 5-button control panel)
(use the 2-button control panel)
5