Power Up - Huntleigh Smartsigns LITE Serie Kurzes Handbuch

HEALTHCARE
3.5 Power-Up
1. Switch On
2. LED will illuminate.
4. Unit is ready
3. Tone will sound
START CYCLE
START
CYCLE
STOP REVIEW
STOP REVIEW
CLEAR
CLEAR
NOTE
If the unit is left idle for 10 minutes, all displays will go blank. Press any
button to re-enter the normal operating mode.
The Smartsigns® LITE Series will emit a short single beep each time the
power supply is plugged into the device, and a short double beep each time
the power supply is removed from the device.
It is recommended to operate with the power supply plugged into the AC
mains supply to maintain battery charge and prolong battery life.
If the low-battery indicator appears ( ), the device needs charging. The
unit will also emit a short double beep every 30 seconds in low battery
condition. A maximum of 20 NIBP or 20 single temperature measurements
may be taken before the unit prevents further operation.
15