Automatic Mode - Huntleigh Smartsigns LITE Serie Kurzes Handbuch

HEALTHCARE
4.3

Automatic Mode

1. - Clear
2. - until required cycle time is displayed (1-5 minutes).
3. - Start
4. Cuff
Inflates
6. Cuff
Deflates
4 - 7 repeated 6 6 times.
8.
Tone will sound*
*Note - To switch this tone On/Off , press and
hold the START key
Reviewing previous readings
1. - displays previous readings, (the number in the READING display
will correspond to the displayed measurement).
2. - clear stored readings before starting a new set of measurements.
NOTE
If an error code is displayed for any reading, that reading is not included in
the average.
If 1 or 2 minute cycle times are selected and the patient's blood pressure is
high then any individual measurement may take longer than 1 or 2 minutes.
The Smartsigns® LITE Series will not begin a new measurement until the
cuff is fully deflated from the previous measurement.
Pressing
to resume.
between measurements will suspend Automatic Mode. Press
5. Cuff
Pressure
Displayed
7.
Measurement
Displayed
9. Average
Measurement
Displayed.
on Power Up.
START CYCLE
STOP REVIEW
CLEAR
START CYCLE
STOP REVIEW
CLEAR
START CYCLE
STOP REVIEW
CLEAR
17