Cleaning; Troubleshooting - Parkside PLBS 30 B2 Bedienungs- Und Sicherheitshinweise

Cleaning

e
d
CAUTION - DANGER OF BURNS! Allow the
soldering iron to cool completely before cleaning. To avoid
damage, do not use aggressive cleaning material, metal brushes
or sharp objects such as knives, etc.
• Clean the device with a soft, slightly damp cloth if required. Ensure that no moisture enters
the device.
• Clean the soldering tips with the help of the cleaning sponge included in the pack
contents.

Troubleshooting

Fault
Soldering iron does not
heat up.
The temperature of the
soldering tip is too low.
The solder does not run
smoothly on the soldering
iron.
Possible cause
No power supply.
Mains cable or plug
damaged.
Soldering tip is loose.
The soldering tip is not hot
enough.
Troubleshooting
Check that the mains supply
(socket) functions correctly.
Ask a competent person for advice
if necessary.
Have the mains cable replaced
by the manufacturer or the
manufacturer's representative.
Disconnect the soldering iron from
the mains. Allow the soldering iron
to cool down. Screw the soldering
tip firmly into the tip holder.
Wait until the soldering iron is hot
enough.
Allow the soldering iron to cool
down completely and check
whether the soldering tip is loose.
57