Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Stand-alone mode
Automatic mode
In automatic mode, 12 different show programs are available that run at an adjustable speed.
1
Press the MENU button so many times until the menu structure is indicated in the display. Use UP and
DOWN to select AUTO. Confirm 2 x with the ENTER button.
2
Use UP and DOWN until the display shows Program. Confirm with the ENTER button.
3
Use UP and DOWN to select the number of the desired program. Confirm with ENTER.
4
Use UP and DOWN until the display shows Speed. Confirm with the ENTER button. The display
indicates menu item running speed.
5
Use UP and DOWN to adjust the running speed of the program from 01 (slow) to 99 (fast). Confirm with
ENTER.
Sound control
Via the integrated microphone the unit can perfectly reproduce the 12 show programs to the rhythm of the
music (sufficient bass provided).
1
Press the MENU button so many times until the menu structure is indicated in the display. Use UP and
DOWN to select SOUND. Confirm 2 x with the ENTER button.
2
Use UP and DOWN to select the number of the desired program. Confirm with ENTER.
3
Use the rotary control MICROPHONE SENSITIVITY to adjust the microphone sensitivity to the sound
volume. In case of missing sound signal, the LEDs are either switched off after 5 seconds or hold the
most recent light effect. This function can be found under the menu item SETTINGS > SOUND.
Individual dim mode
In the dim mode MANUAL each of the LED spots (Spot 1- Spot 4) can be individually adjusted for
brightness. Select Strobe to adjust the speed of the strobe effect for all spots at the same time.
1
Press the button MENU so many times until the menu structure is indicated in the display. Use UP and
DOWN to select MANUAL. Confirm 2 x with the ENTER button.
2
Select the desired spot (Spot 1- Spot 4) using the UP and DOWN buttons. Confirm with ENTER.
3
Use the UP and DOWN buttons to adjust the desired brightness.
4
Confirm with ENTER. Now the brightness of the next spot can be adjusted.
5
The setting of the strobe speed is the final menu item. Use UP and DOWN to select the desired strobe
speed STROBE. Confirm with ENTER.
6
Use the UP and DOWN buttons to adjust the desired strobe speed from 001 (slow) to 099 (fast) or 000
(no flashing).
7
Confirm with ENTER.
Master/slave operation with several light sets
Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled
with the master unit without the need for a DMX controller. The devices must be set to the corresponding
operating modes.
1
Configure all slave units before connecting the master unit. For this, press the MENU button so many
times until SLAVE is indicated in the display. Confirm with the ENTER button. The display now indicates
SLAVE.
2
Confirm with ENTER. The display will indicates SLAVE in red until control signals are being received
from the master unit, then SLAVE will light in green.
3
Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller
to the DMX input of the master unit.
4
Select the desired show program or dim mode at the master unit. The interconnected light sets will now
operate in synchronously.
26/32
00127688, Version 1.0
Werbung
Inhaltsverzeichnis
