Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Stand-alone mode
Automatic mode
In automatic mode, 7 show programs are available that run at an adjustable speed.
1
Press the MENU button so many times until Auto is indicated in the display. Confirm with the ENTER
button. Use the buttons UP and DOWN to select the desired show program. Confirm with the ENTER
button.
2
Press the MENU button so many times until SPEd is indicated in the display. Confirm with the ENTER
button. Use the buttons UP and DOWN to adjust the running speed of the program from SP 1 (slow) to
SP 9 (fast). Confirm with the ENTER button.
Sound control
Via the integrated microphone the unit can perfectly reproduce the show programs to the rhythm of the
music (sufficient bass provided).
1
Press the MENU button so many times until Sond is indicated in the display. Confirm with the ENTER
button. Use the buttons UP and DOWN to select the desired show program. Confirm with the ENTER
button.
2
Press the MENU button so many times until SEnS is indicated in the display. Confirm with the ENTER
button. Use the buttons UP and DOWN to Adjust the microphone sensitivity to the volume of the music
(SE 1 = low, SE 9 = high).
3
If you enable the silent scene mode (on setting) in menu item SILE, the LEDs will be switched off if the
volume is too low or if there is no sufficient bass beat. If you disable this mode (off setting) the LEDs
remain on during periods without music.
Display representation
Menu dISP allows adjusting the display representation.
1
Press the MENU button until the display shows dISP. Confirm with the ENTER button.
2
Use the buttons UP and DOWN to switch between normal representation (dISP) and reversed
representation (dSiP). Confirm with the ENTER button.
Interconnecting several devices (master/slave operation)
Several devices may be interconnected (max. 32). Then all slave units can be synchronously controlled with
the master unit without the need for a DMX controller. The devices must be set to the corresponding
operating modes.
1
Configure all slave units before connecting the master unit: Press the MENU button so many times until
SLAU is indicated in the display. Confirm with the ENTER button.
2
Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller
to the DMX input of the master unit.
3
Set the master unit to the desired operating mode. The interconnected devices will now operate in sync.
24/32
00116304, Version 1.0
Werbung
Inhaltsverzeichnis
