Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Mounting on a stand
For mobile use, place the light set on a lighting stand via the TV spigot and fasten
the fixation screw. Suitable stands can be found in chapter Accessories.
Notes:
• Please make sure the load is installed in a balanced way and the carrying capacity
of the stand is not exceeded.
• Install the stand on a plane area (inclination angle max. 5°) and out of the reach of
people.
• Depending upon the individual installation spot, all necessary measures to prevent
displacement or tilting (also in case of fire) have to be taken.
Fastening/removing the frost filter
To achieve the beam angle 15° or 22°, please install the respective frost filter.
These can be simply attached by placing the desired frost filter over the lens using
the fixation rings. Remove the fixation ring by pressing the ring together. Remove
the frost filter and insert the new filter. Press the fixation ring together and insert it in
front of the filter.
Before fastening/removing the frost filter unplug mains lead.
CONNECTIONS
DMX Controller
Program
Chase32 Step100
DMX512 control
A DMX512 data link is required in order to control the device via DMX. The device provides 3-pin XLR
connectors for DMX connection.
1
Connect the output of your DMX controller to the DMX input DMX IN of the light set with a DMX cable.
2
Connect the DMX output DMX OUT of the light set to the DMX input of the next unit in the chain. Always
connect one output to the input of the next unit until all units are connected.
3
At the last unit, the DMX cable has to be terminated. Plug the terminator with a 120 Ω resistor between
Signal (–) and Signal (+) in the DMX output of the last unit.
4
If the cable length exceeds 300 m or the number of DMX devices is greater than 32, it is recommended
to insert a DMX level amplifier to ensure proper data transmission.
XLR connection:
Device 1
Start Address 1
23/32
Device 2
Start Address 9
Device 3
Start Address 17
00127688, Version 1.0
Werbung
Inhaltsverzeichnis
