Operation; Stand-Alone Mode; Master/Slave Operation; Master/Slave Operation Via Quickdmx - EuroLite TL-3 TCL Bedienungsanleitung

OPERATION

After you switch on the device with the power switch, the device starts running. The display lights up and you
can choose the desired mode via the buttons MENU, ENTER, UP, DOWN.
The device has two operating modes. It can be operated in stand-alone mode via the control board and the
EUROLITE IR-13 remote control or in DMX-controlled mode via a standard DMX controller and QuickDMX
with suitable wireless transmitter.

Stand-alone mode

In the stand-alone mode, you can do without a controller. Disconnect the device from the controller and call
the desired setting. Please refer to the instructions under Control Board.

Master/Slave operation

The master/slave operation enables that several devices can be synchronized and controlled by one master
device.
On the rear panel of the device you can find an XLR jack and an XLR plug, which can be used for
connecting several devices.
Choose the device which is to control the effects. This device then works as master device and controls all
other slave devices, which are to be connected to the master device via a DMX-cable. Connect the OUT jack
with the IN plug of the next device.
Set the master device to the desired mode (all except Addr and SLAU). Set the slave mode (SL.AU) on
every slave device. Please refer to the instructions under Control Board.

Master/Slave operation via QuickDMX

Set the master device and each slave device to the same transmission channel. For this purpose, press the
button ID on the device, to change the transmission channel and pair the devices.
The selected transmission channel is indicated by the status indicator.
Channel Color
1 Red
2 Green
3 Blue
4 Yellow (red/green)
5 Cyan (green/blue)
6 Magenta (red/blue)
Choose the device which is to control the effects. This device then works as master device and controls all
other slave devices.
Set the master device to the desired mode (all except Addr and SLAU). Set the slave mode (SL.AU) on
every slave device. Please refer to the instructions under Control Board.
31/40 00125583.DOCX, Version 1.1