Operation; Stand-Alone Mode; Sound Control; Auto-Mix Color-Mode - EuroLite LED ML-56 RGB Bedienungsanleitung

Occupation of the XLR-connection:
If you are using controllers with this occupation, you can connect the DMX-output of the controller directly
with the DMX-input of the first fixture in the DMX-chain. If you wish to connect DMX-controllers with other
XLR-outputs, you need to use adapter-cables.
Building a serial DMX-chain:
Connect the DMX-output of the first fixture in the DMX-chain with the DMX-input of the next fixture. Always
connect one output with the input of the next fixture until all fixtures are connected.
Caution: At the last fixture, the DMX-cable has to be terminated with a terminator. Solder a 120 resistor
between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture.

OPERATION

The device has two operating modes. It can be operated in Stand Alone-mode via DIP Switches or it can be
run in DMX-controlled mode.
After connecting the spot to the mains, the EUROLITE LED ML-56 RGB starts running.
Stand Alone-Mode
You can do without a controller as the LED ML-56 RGB features a built-in microphone, which provides
automatic sound control. You can adjust the sensitivity with the rotary-control on the rear panel.
In order to select Stand Alone Mode, first set dip switch 10 to ON and then switch on your device.

Sound Control

In order to select Sound Control, first set dip switch 10 to ON and 8 and 9 to OFF.
Adjust the sensivity via the Sensivity control.

Auto-Mix Color-Mode

In order to select Auto-Mix Color Mode, set dip switch 9 and 10 to ON and 8 to OFF. Speed (increasing)
can be controlled by setting dip switches 1 - 7 to ON.
21/46 00029367.DOC, Version 1.3