Mounting; Mounting On A Stand; Fixing To A Truss; Safety Instructions Overhead Rigging - EuroLite LED KLS-2500 Bedienungsanleitung

5. MOUNTING

5.1 Mounting on a stand

For mobile use place the light set on a lighting stand. Suitable items can be found in chapter Accessories.
1
On the stand, the fixation screws of the legs. Pull out the legs until the cross struts stand at a 90° angle
to the legs. Tighten the fixation screws of the legs.
2
Attach the light set via its TV pin (Ø = 28 mm) on the control unit to the top end of the stand and fasten
the fixation screw.
3
Caution! The load has to be installed in a balanced way. The carrying capacity of the stand must never
be exceeded. The stand must be set up in a stable way. Make sure all fixation screws fit tight.

5.2 Fixing to a truss

The light set can be fixed to a truss using two C-hooks with M10 screw.
1
In each case, put the head of an M10 screw to the upper side of the control unit and, together with the
C-hooks, screw them down at the extreme ends of the control unit, if possible.
2
Suspend the C-hooks in the truss and tighten the fixation screws.
3
Always install a safety bond. Before rigging, make sure that the installation area can hold a minimum
point load of 10 times the device's weight.

5.3 Safety instructions overhead rigging

Please consider the EN 60598-2-17and the respective national standards during the installation!
The installation must only be carried out by an authorized dealer!
The installation of the device has to be built and constructed in a way that it can hold 10 times the weight for
1 hour without any harming deformation.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net.
This secondary safety attachment must be constructed in a way that no part of the installation can fall down
if the main attachment fails.

DANGER TO LIFE!

27/40
00082823.DOCX, Version 1.0