Maintenance And Cleaning - Abicor Binzel iROB P400 Betriebsanleitung

iROB

9 Maintenance and cleaning

Under normal operating conditions, the robot welding power source iROB does not require maintenance.
Scheduled maintenance and cleaning, however, is a prerequisite for a long life and a trouble-free operation.
Risk of injury due to unexpected start-up
For the entire duration of maintenance, servicing, mounting, dismounting and repair work, the following
instructions must be adhered to:
• Switch off the power source.
• Pull the mains plug.
Electric shock
Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation and damage.
• Replace any damaged, deformed or worn parts.
NOTICE
• Maintenance and cleaning work may only be carried out by qualified personnel (in Germany see
• Always wear your personal protective equipment when performing maintenance and cleaning work.
• Please observe the operating instructions of the welding components, coolant recirculator iCOOL
DANGER
DANGER
TRBS 1203).
(option), wire feeder iFEED (option), remote control iCONTROL (option) and welding torch.
9 Maintenance and cleaning
EN - 19