Mains Connection; Operation - Parkside PHD 170 A1 Originalbetriebsanleitung

GB IE NI
the feed hose. Switch off the water tap.
4. Connect the feed hose with the help of
the quick connector for garden hose
adapter (25) with the water connection
coupling (13) and the water connec-
tion (14) on the device.
5. Connect to the spray gun (16) by
inserting and screwing in the jet pipe
(22).
6. If the jet pipe (22) is mounted, connect
either the turbo dirt mill (24) or the
standard Vario nozzle (18) by screw-
ing in with the jet pipe (22). The at-
tachments snap into place. To remove
the attachments, press the side lock
(23) on the front end of the jet pipe
(22) and pull the attachment forwards
to disconnect it.
7. Screw in to connect the detergent con-
tainer with nozzle (9) directly to the
spray gun (16). With using the clean-
ing agent container with the nozzle
(9), pour only cleaning agent into the
container. It is sucked in automatically.
The amount of detergent sucked in can
be adjusted by turning the control knob
(8) on the nozzle. Pay attention to the
+ / - markings.
8. Connect the rotating washing brush (2)
directly to the spray gun (16) by insert-
ing it and tightening (bayonet fitting).
It is always used without applying
any pressure. The cleaning function is
produced by the rotational movement
and the flow of water. If there is no
water flow, the washing brush does not
rotate.
The roles of the unit, use the handle
(1) only in conjunction with the
wheels (12). For lifting and carrying
use the carrying handle.
The width of the jet can be in-
creased by turning the end of the
nozzle to the left. To reduce the
width of the jet, turn the end of the
nozzle to the right.
10
CY

Mains connection

The pressure cleaner you have acquired
is already fitted with a mains plug. The
equipment is designed for connection to an
earthed wall socket with a RCD (Residual
Current Device) at 230 V ~ 50 Hz.
Only operate the pressure cleaner
after all the above points have been
observed.
1. Ensure that the pressure cleaner is
turned off by its ON / OFF switch (7).
2. Insert the mains plug into the mains
socket

Operation

Be prepared for the recoil
force of the emitted wa-
ter jet! Ensure that you are
standing firmly and that you
are holding the gun (16) se-
curely, otherwise you could
injure yourself or other
people.
Never operate the pressure cleaner
with a closed water tap. Dry run-
ning will damage the pressure
cleaner!
1. Turn on the water tap entirely.
2. Switch on the pressure cleaner with the
ON / OFF switch (7).
Only ever switch on the pressure clean-
er once you have connected all of the
water pipes and they do not leak.
The motor switches on until the re-
quired pressure has built up. After
the pressure has built up, the motor
switches off.
3. Press the gun (16) starting lever (20).
The nozzle operates by pressure and
the motor switches back on.
Releasing the starting lever (20) causes