Charging The Battery; Inserting/Removing The Battery; Recharging The Battery - Parkside PWSA 12-LI A1 Originalbetriebsanleitung

GB MT
Large workpieces may bend
under their own weight. The
workpiece must be supported
on both sides of the disc,
near the cutting disc as well
as also at the edge.
f) Be particularly careful for po-
cket cuts in existing walls or
other areas where you cannot
see what is there. The cutting
disc may cause a kickback
when it cuts into gas or water
lines, electrical lines or other
hidden objects.

Charging the battery

Do not expose the battery to
extreme conditions such as
heat or impact. Risk of injury
from escaping electrolytic so-
lution! After eye/skin contact,
rinse the affected areas with
water or a neutraliser and
consult a doctor.
Charge the battery in a dry
room only.
Prior to attaching the charger,
check that the battery's outer
surface is clean and dry.
There is a risk of injury due
to electric shock.
Only use the original charger from
the package to charge the battery.
Make sure that the power supply
voltage matches the voltage rating
indicated on the device's type plate.
• Charge the battery before the first time
of use.
92
• Recharge the battery when you notice
that the appliance is becoming slower.
• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to
be replaced. Only use an OEM spare
battery available from our Customer
Service.
Inserting/removing the
battery
1. To insert the battery (9), place
it on the guide track and push it
back into the appliance. It will
audibly snap in.
2. To remove the battery (9) from
the appliance, press the release
buttons (8) on the battery and
pull out the battery.

Recharging the battery

1. Remove the battery (9) from the
appliance i necessary.
2. Insert the battery (9) in the charg-
ing compartment of the battery
charger (15).
3. Plug the battery charger (15) into
a mains outlet.
4. When the battery is fully re-
charged unplug the battery
charger (15) from the mains.
5. Pull the battery (9)out of the bat-
tery charger (15).
Overview of the LED indicators on
the charger (15):
Green LED (13) lights up
without battery inserted:
Charger ready.