Safety Instructions For All Applications - Parkside PWSA 12-LI A1 Originalbetriebsanleitung

• Do not use the charger to
charge non-rechargeable bat-
teries.
Safety instructions for
all applications
Common safety
instructions for grinding
and cutting:
• This electric tool is to be used
as a grinder and cutting grin-
der. Follow all safety instruc-
tions, directives, illustrations
and facts which you receive
with the device. If you do not
follow these instructions, an
electrical shock, fire and/or
serious injury may occur.
• This electric tool is not suitable
for sanding, wire brushing
and polishing. Using the elec-
tric tool in ways for which it
is not intended may cause ha-
zards and injuries.
• Do not use any accessories
that are not specifically inten-
ded and recommended for
this electric tool by the manu-
facturer. Simply because an
accessory can be attached
to your electric tool does not
guarantee safe operation.
• The allowable rotation speed
of the attachment tools must
be at least as high as the
highest rotation speed indica-
ted on the electric tool. Acces-
sories that run faster than the
allowable speed can break
and fly apart.
• The outside diameter and
thickness of the attachment
tool must correspond to the
dimensions indicated for your
electric tool. Attachment tools
which are wrongly dimensi-
oned cannot be sufficiently
shielded or controlled.
• Attachment tools with th-
readed attachment must fit
the threading of the grin-
ding spindle exactly. For
attachment tools which are
mounted through a flange,
the diameter of the hole in
the attachment tool must fit
the mounting diameter of
the flange. Attachment tools
which cannot be precisely at-
tached to the electric tool turn
unevenly, vibrate very stron-
gly and can ultimately lead to
a loss of control.
• Never use damaged attach-
ment tools. Check attachment
tools such as grinding discs for
chipping or cracks, grinding
plates for cracks, wear or
strong abrasion before using
them. If the electric tool or the
attachment tool falls off, check
whether it is damaged or use
an undamaged attachment
tool. If you have checked the
attachment tool and attached
it, keep yourself and any ne-
arby persons beyond the level
of the rotating attachment tool
and allow the device to run
for 1 minute at the highest ro-
tational speed. Damaged tools
usually break during this test
period.
GB MT
87