Scope Of Delivery; General Power Tools Safety Warnings - Parkside PAH 1300 B2 Bedienungs- Und Sicherheitshinweise

Guaranteed sound power level
in dB.
Total vibration value:
Total vibration values (vector total of three directions)
determined in accordance with EN 60745:
Main handle:
Chiselling: a = 16.475 m / s , K = 1.5 m / s
Auxiliary handle:
Chiselling: a = 17.242 m / s , K = 1.5 m / s
NOTE
The vibration level specified in these instruc-
tions has been measured in accordance with
a standardised measuring procedure and can
be used to make product comparisons. The
specified vibration emission value can also be
used to make an initial exposure estimate.
The vibration level varies in accordance with
the use of the product and may be higher than
the value specified in these instructions in some
cases. Regular use of the product in such a
way may cause the user to underestimate the
vibration. Try to keep the vibration loads as low
as possible. Measures to reduce the vibration
load are, e.g. wearing gloves and limiting the
working time. Wherein all states of operation
must be included (e.g. times when the product
is switched off and times where the product is
switched on but running without load).

Scope of delivery

1 demolition hammer PAH 1300 B2
1 additional handle (pre-assembled)
1 flat chisel
1 pointed chisel
1 carrying case
1 set of operating instructions
General power tools
safety warnings
Read all safety directions and instructions.
Failure to follow the warnings and instructions may
result in electric shock, fire and / or serious injury.
Save all warnings and instructions for
future reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-op-
erated (cordless) power tool.
Work area safety
a) Keep work area clean and well lit.
Cluttered or dark areas invite accidents.
b) Do not operate power tools in explo-
sive atmospheres, such as in the pres-
ence of flammable liquids, gases or
dust. Power tools create sparks which may
ignite the dust or fumes.
c) Keep children and bystanders away
while operating a power tool. Distrac-
tions can cause you to lose control.
Electrical safety
a) Power tool plugs must match the out-
let. Never modify the plug in any way.
Do not use any adapter plugs with
earthed (grounded) power tools. Un-
modified plugs and matching outlets will reduce
risk of electric shock.
b) Avoid body contact with earthed or
grounded surfaces, such as pipes,
radiators, ranges and refrigerators.
There is an increased risk of electric shock if
your body is earthed or grounded.
c) Do not expose power tools to rain or
wet conditions. Water entering a power
tool will increase the risk of electric shock.
d) Do not abuse the cord. Never use the
cord for carrying, pulling or unplug-
ging the power tool. Keep cord away
from heat, oil, sharp edges or moving
GB 7