Safety Instructions For Operating The Device - Gloria MULTIBRUSH Betriebsanleitung

rinse the affected area thoroughly with
water and consult a doctor. Ensure ade-
quate fresh air and consult a doctor if
you experience irritation of respiratory
tracts, skin or eyes.
2.3 Safety instructions for
operating the device
ATTENTION
Improper use of the device poses a
risk of damage to property! You should
therefore observe the following safety
instructions:

Do not use the device with wet hands.

Do not immerse the device in water
or spray or clean it with water.
The device must be protec ted
against moisture.

NEVER operate the device at tem-
peratures below 0° C.
OVERLOAD PROTECTION!

Your MultiBrush li-on has protection
against overloading. The unit switches off
automatically if you stress it excessively
(too much pressure on the brush). In this
case you should release the On / Off safety
switch (D) to reset the overload protecti-
on. Switching on again with the On / Off
safety switch (D) allows you to continue
working immediately with the MultiBrush
li-on. Reduce the force applied to the
brush by not pressing so hard.
TEMPERATURE PROTECTION

Your MultiBrush li-on has protection
against excessively high temperatures of
the rechargeable battery. The battery
cells can overheat if you use the unit
constantly over a longer period of time
or if it is exposed to high ambient tem-
peratures. Discharge is no longer possi-
ble above 70 °C. In such a case, the device
switches itself off automatically (all 4 dis-
plays flash, see also section 7.1.1). Allow
the rechargeable battery (C) to cool
down again before switching on again.
LOW VOLTAGE CUTOFF DEVICE!

Your MultiBrush li-on has a low voltage
cutoff device for the rechargeable batte-
ry. This functions switches the unit off
immediately if the voltage falls below a
specified value (all 4 displays flash, see
also section 7.1.1). In such a case you
should recharge the battery (C) or else
put a fully charged battery into the unit.
CAUTION
RISK OF BURNS CAUSED BY HOT
PARTS!
Parts of the device can become hot
during use and may cause burns.
It is therefore important to observe the
following safety instructions:

Wear protective gloves during
assembly and cleaning work!
Observe the
precautions to prevent injuries and
material damage due to misuse and
unsafe handling of the product. Misuse
can result in INJURIES.
WARNING
RISK OF INJURY DURING OPERATION!

Use the device
Work only within the specified
perform ance range.

Before each use, make sure that the
device is in perfect condition;
operation is prohibited if:
- the safety devices (start switch,
protective covers) and/or brushes
are damaged or worn.
- the device shows visible signs of
damage.
- the device may have been
dropped before.
- foreign objects have wrapped
around the drive shaft.
Never disable any safety devices.

Check area to be cleaned beforehand
to avoid damage to device / objects
or injuries to living beings. Stones,
pieces of wood, wires or the like, as
well as other foreign objects must be
removed. Objects that are caught by
26
following safety
as intended!