General Description; Overview; Functional Description; Scope Of Delivery - FLORABEST FTP 400 A1 Originalbetriebsanleitung

GB CY

General Description

The diagram of the most im-
portant functional elements
can be found on the foldout
side.

Overview

1 Mains cable
2 Handle
3 Float switch cable
4 Float switch guideway
5 Float switch height-adjustment
6 Float switch
7 Round handle of the rotary disk
(not visible)
8 Rotary disk
9 Arrow on rotary disk
10 Pump base
11 Pump output
12 Pump casing
13 Adapter with hose connection
14 backflow stop with seal
(not visible)
15 Angle adapter
16 Cable holder
17 9 m cord with loop

Functional description

The immersion pump has a shock-resist-
ant plastic casing.
It has a cooling jacket, through which the
pumped water flows around the motor to
the pump outlet. The pump is fitted with a
float switch, which automatically switches
the equipment on or off.
In addition, the pump also has a backflow
stop that prevents water from flowing
back, for example during an interruption in
the power supply.
8
(not visible)
(not visible)

Scope of Delivery

Carefully unpack the appliance and check
that it is complete:
- Immersion pump
- Angle adapter + adapter with hose
connection
- 9 m cord with loop
- Cable holder

Start-up

To screw-on the adapter

Screw the angle adapter (15) and
the adapter with the hose attach-
ment (13) onto the pump outlet (11).
To mount the float switch
height adjustment
Loosen the screw of the float
switch height adjustment (5) and
push the adjustment over the float
switch guideway (4). Check that
the float switch cable (3) moves
upward (arrow
„Operation").

To fit the cable holder

Push the cable holder (16) from
the package all the way into the
guideway at the back of the pump
casing (12).
Connection of the pressure
line
The installation of the immersion pump is
implemented either
- with fixed pipe or
- with flexible hose line
to point up) (see