Storage; Guarantee - FLORABEST FGH 700/10 Bedienungs- Und Sicherheitshinweise

GB IE CY
3. Clean the driveshaft
4. Slide the new tines onto
Make sure that the tines are set to their
proper turning direction. The arrows on
the gearbox and tines should point the
D
same way (
5. Slide the hex bolt through the hole
and tighten on the self-locking nut
(supplied with each new tine wheel
pair 23).

Storage

• Leave the motor to cool down before you
put the tool into a closed space.
• Keep the tool clean, dry and out of the
reach of children.
Unscrew the wing nuts
A
( No. 4) and fold the fork grips down to re-
duce the space taken by the tool.
Make sure that the cable does not become
jammed.
• The frame tubing (
as a hook to hang up the tool at the place
of storage.
• Do not cover the tool in plastic bags as
moisture may form.
Do not use the tool with the handle
folded closed.
10
with biological oil.
the driveshaft with the
holes on the axles
aligned to the holes on
the driveshaft (21).
No. 22).
B
No. 5) also serves

Guarantee

• This tool is subject to a guarantee period
of thirty-six months. A shorter guarantee
period of 12 months shall apply for com-
mercially used and replacement tools ac-
cording to statutory regulations.
If you have a justified guarantee claim,
please contact us at our service cen-
tre (see last page for our telephone
number, fax number, and e-mail ad-
dress). We will then give you the de-
tails on the claims procedure.
• Damage caused by natural wear, over-
load, or improper use is not covered by
guarantee. Certain components are sub-
ject to normal wear and are not covered
by guarantee. Such components particu-
larly include: tines.
• Guarantee service is also conditional
upon compliance with cleaning and main-
tenance instructions
• Any damage caused by faults in materials
or manufacturing shall be remedied by
free repair or replacement.
• You may have repairs not covered by
guarantee carried out for a charge at our
service centre. Our service centre will be
pleased to supply you with a cost esti-
mate.
We can only process orders on tools sent
in with adequate postage and packing.
•
Tools sent in by express, measurement
cargo or other special forms of post-
age with freight collect will be refused.
• We will dispose of tools free of charge.