Specifications - Makita 4105KB Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Wing nut
1-2. Base
2-1. Notch
3-1. Switch trigger
3-2. Lock-off button
4-1. Switch trigger
5-1. Restart button

SPECIFICATIONS

Wheel diameter
Max. wheel thickness
Max. cutting capacity
Rated speed (n) / No load speed (n
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for cutting in brick and concrete
without the use of water.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Wear ear protection
Vibration
The vibration total
determined according to EN60745:
Work mode : concrete cutting
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Explanation of general view
6-1. Outer flange
6-2. Base
6-3. Thumb nut
7-1. Socket wrench
7-2. Wrench
8-1. Inner flange
8-2. Diamond wheel
Model
)
0
Overall length
Net weight
Safety class
) : 102 dB (A)
pA
) : 113 dB (A)
WA
value (tri-axial vector
2
) : 5 m/s
h
2
ENE024-1
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
ENF002-1
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
ENG905-1
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
For European countries only
ENG900-1
EC Declaration of Conformity
We Makita
sum)
manufacturer declare that the following Makita
machine(s):
Designation of Machine:
Dustless Cutter
Model No./ Type: 4105KB
are of series production and
Conforms to the following European Directives:
2006/42/EC
3
8-3. Outer flange
8-4. Hex bolt
9-1. Dust spout
11-1. Limit mark
12-1. Screwdriver
12-2. Brush holder cap
4105KB
125 mm
2.1 mm
40 mm
-1
9,000 (min )
230 mm
3.1 kg
/II
Corporation as the
ENG901-1
ENH101-16
responsible