ENGLISH (Original instructions)
1-1. TEST button
1-2. RESET or "ON" button
1-3. Pilot lamp
1-4. Portable residual current device
(PRCD)
2-1. Wing bolt
2-2. Base
3-1. Wing nut
4-1. Wing bolt
4-2. End of blade case
4-3. Red line
SPECIFICATIONS
Wheel diameter
Max. wheel thickness
Max. cutting capacities
Max. permitted pressure of water supply
Rated speed (n) / No load speed (n
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
・
Read instruction manual.
・
Wear safety glasses.
・
The tool should be used on horizontal
surfaces.
・
Do not use the tool upside down.
・
The tool should be used with the PRCD
(Portable Residual Current Device).
・
Do not use the abrasive cut-off wheel.
・
After use, brush off accumulation of
dust on the base.
・
Do not use the saw blade.
・
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In
observance
Directive,
Electronic
Explanation of general view
5-1. Base
5-2. Top guide
6-1. Switch trigger
6-2. Lock-off button
7-1. Wrench 22
7-2. Hex wrench
8-1. Inner flange
8-2. Diamond wheel
8-3. Outer flange
8-4. Hex socket head bolt
9-1. Wing bolt
Model
90°
45°
)
0
Overall length
Net weight
Safety class
of
the
on
Waste
Electric
Equipment
END104-6
Intended use
The tool is intended for cutting in brick, concrete and
stone.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. This
tool should be grounded while in use to protect the
operator from electric shock. Use only three-wire
extension cords which have three-prong grounding-type
plugs and three-pole receptacles which accept the tool's
plug.
European
and
and
its
3
9-2. Blade case
9-3. Water pipe
10-1. Clamp
10-2. Cover (A)
12-1. Clamp
12-2. Cover (A)
13-1. Cover (B)
13-2. Screw
14-1. Limit mark
15-1. Brush holder cap
15-2. Screwdriver
4101RH
125 mm
2.1 mm
41.5 mm
26 mm
0.14 MPa
-1
13,800 (min
)
236 mm
3.0 kg
Class I
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an
environmentally
recycling facility.
compatible
ENE023-2
ENF001-1