Specifications - Makita 4112HS Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Wing bolt
1-2. Base
1-3. Cutting depth
2-1. Clamping nut
2-2. Wheel guard
3-1. Switch trigger
3-2. Lock lever
4-1. Shaft lock
4-2. Socket wrench

SPECIFICATIONS

Max. wheel thickness
Max cutting capacity
Rated speed (n) / No load speed (n
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for cutting tracks in concrete walls
or cutting in ferrous materials or concrete drainage
channels with a diamond wheel but without using water.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical A-weighted
according to EN60745:
Model 4112S, 4112HS
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Model 4114S
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Wear ear protection
Explanation of general view
5-1. Flange
5-2. Ring
5-3. Wheel
5-4. Flange
5-5. Hex bolt
6-1. Notch
6-2. Cutting line
7-1. Commutator
7-2. Insulating tip
Model
Wheel diameter
)
0
Overall length
Net weight
Safety class
noise level determined
) : 102 dB (A)
pA
) : 113 dB (A)
WA
) : 103 dB (A)
pA
) : 114 dB (A)
WA
4112S
3.5 mm
3,800 (min
ENE026-1
Vibration
The vibration
determined according to EN60745:
Model 4112HS
ENF002-2
Work mode : concrete cutting
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Model 4112S, 4114S
ENG905-1
Work mode : concrete cutting
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
3
7-3. Carbon brush
8-1. Dust cover
8-2. Screwdriver
8-3. Brush holder cap
9-1. Dust nozzle
9-2. Elbow joint
9-3. Hose
4112HS
305 mm
3.5 mm
100 mm
-1 -1
) 5,000 (min )
648 mm
11.4 kg
/II
total value (tri-axial
) : 3.5 m/s
h
2
) : 4.0 m/s
h
2
4114S
355 mm
3.5 mm
125 mm
-1
3,800 (min )
675 mm
12.8 kg
ENG900-1
vector sum)
2
2
ENG901-1