Using The Stand; Mounting The Unit To A Wall; Measuring Tip Holder In The Rubber Protector; On/Off Button Power - Wetekom 90 45 16 Bedienungsanleitung

Operating Elements and Connections

Using the Stand

The unit is fitted with a stand integrated in the rubber protector for
propping it up on a table or similar. To use the stand, simply grip
the lower end of the stand frame and pull it outwards.

Mounting the Unit to a Wall

There is a nail slot in the back of the rubber protector which can
be used to mount the unit to a wall.

Measuring Tip Holder in the Rubber Protector

There are two holders for the probe tips on the back of the rubber
protector. If you do not have the opportunity to set down the unit
and need to take several rows of measurements, you can simply
clip one probe tip into one of the holders.
Now you can hold the unit in one hand with one probe tip at-
tached, and the other probe tip in the other hand.
ON/OFF Button (9) POWER
Press this button to turn the unit on or off.
The unit is equipped with an auto-off function, which turns off
15 minutes after last use. To turn the unit on again, turn it off and
on.

HOLD Button (3)

Use the HOLD button to "freeze" the last measured value on the
display. When you turn off this function, the current value is
displayed.
27