Panasonic AW-PH360L Bedienungsanleitung Seite 42

Connections
 DC 12V IN connector (terminal block)
[When connecting the AW-PS300A]
Connect this to the DC 15V OUT
connector on the AW-PS300A.
(The voltage output from the
AW-PS300A is set to 15 V: this takes
into consideration the voltage drops
due to the possible extension of the DC
cable between the pan-tilt head and
AW-PS300A.)
Make sure that the positive
negative ends of the wires are
connected to the same signs on the
connector.
Use a cable with a nominal cross
section of 1.25 mm
the UL specifications for the connection.
The maximum allowable cable length is
30 meters.
[When connecting the AW-PS550]
Use the DC cable (3 meters) supplied to
connect the AW-PS550.
Connect the red wire of the DC cable to
the side on the terminal block, and
the black wire to the
The DC cable supplied must be used
without fail for this connection.
and
2
or more that meets
side.
- 41 (E) -
 LAMP CONTROL connector
(terminal block)
Connect this only when the power of
a halogen lamp is to be supplied from
the AC adapter for use with the pan-tilt
head (AW-PS300A).
This connector is connected to LAMP
CONTROL on the AC adapter for the
pan-tilt head.
The symbols C and S on the wires
must match the same symbols on the
connector.
Use a cable with a nominal cross
section of 0.3 mm
the UL specifications for the connection.
The maximum allowable cable length is
30 meters.
 OP connector (terminal block)
Connect this only when the OP SW
CONTROL OUT connector on the AC
adapter for use with the pan-tilt head
(AW-PS300A) is to be used.
Connect it to the OPTION SW
CONTROL IN connector on the AC
adapter for use with the pan-tilt head
(AW-PS300A).
Use a cable with a nominal cross
section of 0.3 mm
the UL specifications for the connection.
The maximum allowable cable length is
30 meters.
2
or more that meets
2
or more that meets