Tilting Arm Fixing Screws M4 C 12 Mm; Camera Mounting Plate; Guide Screws; M4 C 18 Mm - Panasonic AW-PH360L Bedienungsanleitung

Parts and their functions
Tilting arm
This tilts in the vertical direction.
Tilting arm fixing screws
M4 C 12 mm (4 screws supplied)

Camera mounting plate

This is used to mount the camera.
(See page 17)

Guide screws

These are used to maintain the
camera's balance and anchor the
camera mounting plate.
M4 C 18 mm (2 screws supplied)
Guide pin
This determines the mounting direction
of the camera.
Camera mounting screws
(U1/4-20 UNC)
These are used to mount the camera
and anchor it securely.
(See page 32)
Head
This rotates in the horizontal direction.
Tally lamps (C2)
These light (red) when the tally input is
ON.
They blink for several seconds when
the unit starts operating, and they also
blink when one of the safe modes is
established.
 Head connector panel
This is used for connection with the
camera and lens.
Before use
 Base
 Pan-tilt head mounting holes
These 4 holes are used for mounting
the pan-tilt head. (for hexagon head
bolts C4)
 Base connector rear panel
This is used for connection with a
controller, an AC adapter or a monitor.
 Base connector front panel
This is used for connection with a
camera control, a personal computer or
a monitor.
 Underneath support plate
Besides the four locations of pan-tilt
head mounting holes, use the hole
(8.5 mm, one location) of the
underneath support plate to anchor the
pan-tilt head to prevent the unit from
falling.
 Wire attachment hole
This threaded hole is used to attach the

drop-prevention wire.

When attaching the wire, use the
mounting screw for wire (M4 C 8 mm)
supplied.
- 12 (E) -