Panasonic AW-PH360L Bedienungsanleitung Seite 29

Installation
<When using anchors with an internal thread>
<For stand-alone installation>
Hexagon head bolt (M6)
Spring washer
Flat washer
Hexagon head bolt (M8)
Spring washer
Flat washer
OK example:
The unit is secured by holding its base
part.
OK
p Use a torque wrench whose torque can be specified to tighten the hexagon head bolts or nuts
Notes
at the torque levels listed in the table below.
After tightening the bolts, check for play.
p When installing the pan-tilt head, do not forcibly turn the "head" or "tilting arm" manually. Doing
so may result in malfunctioning.
(Be sure to ask your dealer to install the unit.)
The anchors must always be
installed.
Installing the pan-tilt head
Hexagon head bolts or nuts (M6)
Hexagon head bolt (M8)
- 28 (E) -
Installation work
<For installation on the ceiling>
The anchors must always be
installed.
Secure the underneath support
plate by tightening bolt.
NG example:
The unit is installed by holding its tilting
part.
NG
Clamping torque
5.0 N m (50 kgf
•
12.0 N m (120 kgf
•
cm)
•
cm)
•