Panasonic AW-PH360L Bedienungsanleitung Seite 15

Installation
<Notes>
p Before setting the switches, make absolutely sure that the power of the AC adapter
which is to be connected to the pan-tilt head is set to OFF.
p The controller selection and landing characteristics are not changed simply by
selecting the switch positions. They are changed only after the power is turned off
and back on again after the switches have been set.
p Do not change the positions of switches #1 to #3 and #5 to #8 of SW4 because
these switches are used for maintenance purposes.
For stand-alone
installation
RS-232C
Do not change the setting of this switch —
use it at the RS-422 position.
(Be sure to ask your dealer to install the unit.)
For installation
on the ceiling
RS-422
- 14 (E) -
Installation work
RP501 RP605