Panasonic AW-PH360L Bedienungsanleitung Seite 26

Installation
<Positions and dimensions of mounting holes>
Base connector rear panel side
Check the positions and dimensions of the mounting holes above, and check which is the base
connector rear panel side. Then decide in which direction the pan-tilt head is to be mounted, and
fashion the anchors.
Note Determine the length of the external threads or depth of the internal threads of the anchors after
factoring in the thickness of the mounting areas of the pan-tilt head (10 mm) and thickness of the
drop prevention underneath support plate (1.6 mm).
(Be sure to ask your dealer to install the unit.)
113 mm
74 mm
of pan-tilt head
- 25 (E) -
4-M6 holes
(for mounting the pan-tilt head)
M8 hole
(for mounting the underneath
support plate)