Panasonic AW-PH360L Bedienungsanleitung Seite 39

Connections
Connecting the base connector rear panel and the base
connector front panel
1394 connector
Connect the AK-HRP150 to this
connector when controlling the camera
(AK-HC1500 or AK-HC1800) using
the AK-HRP150. Obtain the optional
cable kit (AW-CAK4H1) to make this
connection.
<Note>
p This unit cannot be controlled directly
using an IEEE1394 interface.
CONTROL IN IP/RP connector
This is for camera/pan-tilt head control
signals.
It is connected to the control
input/output connector on the controller.
Use a 10BASE-T straight cable (UTP
category 5) for the connecting cable.
<Notes>
p Depending on the controller to be
used, it may be necessary to change
the switch positions.
For the switch positions, refer to
"1. Setting the switches" (page 13).
p DO NOT insert any telephone line
connector to this terminal.
Installation work
Y OUT connector
This is for camera video signal output.
Connect this to a monitor, etc.
Use a coaxial cable (BNC) for the
connecting cable.
 Pr OUT connector
This is for camera video signal output.
Connect this to a monitor, etc.
 Pb OUT connector
This is for camera video signal output.
Connect this to a monitor, etc.
Use a coaxial cable (BNC) for the
connecting cable.
 G/L IN connector
This is for genlock signal input.
The genlock signals differ depending on
the type of camera which is mounted.
Input the genlock signals supported by
the camera concerned.
Use a coaxial cable (BNC) for the
connecting cable.
- 38 (E) -