Carrying Out A Firmware Update; Device Information - Anton Paar DMA 35 Betriebsanleitung

11.2 Carrying out a Firmware Update

Your Anton Paar representative will inform you when a new firmware update for your
DMA 35 is available. After receiving the update file, you can import it into the
instrument.
1. If your PC has no IrDA interface, install the IrDA USB adapter on your PC.
2. Hold the IrDA interface of DMA 35 to the IrDA interface of the PC to establish
communication between the two instruments.
3. Press <Menu> and select "Setup > Import / Export > Receive from PC".
4. On the PC right mouse-click on the file you want to send and select "Send to >
A nearby computer".
The firmware update is sent to DMA 35. After the successful file import, DMA 35
checks the validity of the update file.
5. Press <OK> to start the installation when "Import valid" is shown.
The progress bar shows you the progress of the installation. After successful
installation the instrument switches itself back on.

11.3 Device Information

Information about the instrument is saved in the instrument and can be accessed or
exported at any time. This information includes the following:
• Manufacturer
• Instrument name
• Serial number
• Instrument status:
• Measuring data: xxxx/1024
• IDs: xxx/100
• Methods: xx/20
• Firmware version
• Date of the firmware version
• Bootloader version
• Date of the bootloader version
• Hardware status
• RFID module version
C96IB01
EN
59