EN
2
Safety Instructions
•
Read this instruction manual before using the portable density meter DMA 35.
•
Follow all hints and instructions contained in this instruction manual to ensure
the correct use and safe functioning of DMA 35.
Liability
•
This instruction manual does not claim to address all safety issues associated
with the use of the instrument and samples. It is your responsibility to establish
health and safety practices and determine the applicability of regulatory
limitations.
•
Anton Paar GmbH only warrants the proper functioning of DMA 35 if no
adjustments have been made to the mechanics, electronics, and firmware.
•
Only use DMA 35 for the purpose described in this instruction manual. Anton
Paar GmbH is not liable for damages caused by incorrect use of DMA 35.
Installation and use
•
DMA 35 and DMA 35 Tag&Log are not explosion-proof instruments and
therefore must not be operated in areas with risk of explosion.
•
Never remove the pump lock and battery cover in hazardous areas. Only
exchange the batteries outside of hazardous areas.
•
The installation procedure shall only be carried out by authorized personnel who
are familiar with the installation instructions.
•
Do not use any accessories or wearing parts other than those supplied or
approved by Anton Paar GmbH.
•
Make sure all operators are trained to use the instrument safely and correctly
before starting any applicable operations.
•
In case of damage or malfunction, do not continue operating DMA 35. Do not
operate the instrument under conditions which could result in damage to goods
and/or injuries and loss of life.
•
Check DMA 35 for chemical resistance to the samples and cleaning liquids.
•
Do not expose the instrument to temperatures below 0 °C (32 °F) if water is
contained in the measuring cell or pump (freezing water will cause rupture of the
measuring cell).
10
C96IB01