Defining The Basic Settings; Language Settings; Units; Sound Settings - Anton Paar DMA 35 Betriebsanleitung

EN
8

Defining the Basic Settings

8.1

Language Settings

You can choose between two different menu languages:
1. Press <Menu> and select "Setup > Language".
2. Select the preferred language and press <OK>.
8.2

Units

1. Press <Menu> and select "Setup > Units".
2. Select g/cm
3. Select °C or °F as the temperature unit and press <Save>.
Your settings are saved and the measuring results are shown in the selected
units.
8.3

Sound Settings

When sound is enabled, DMA 35 beeps when it is switched on and off and when a
key is pressed.
When sound is disabled, the instrument only beeps when it is switched on and off.
1. Press <Menu> and select "Setup > Beep".
2. Select the preferred setting (Beep on/off) and press <Save>.
8.4

Energy Saving Mode

Enabling the energy saving mode lowers the power consumption of the instrument
and thus extends battery life. When the energy saving mode is enabled, the
instrument will automatically switch itself off after 3, 5 or 10 minutes of inactivity.
When the energy saving mode is disabled, the instrument will remain switched on
until it is turned off using the
1. Press <Menu> and select "Setup > Energy Saving".
2. Select the preferred setting (Off, 3, 5 or 10 minutes) and press <Save>.
24
3 or kg/m as the density unit and press <OK>.
3
key.
C96IB01