Inhaltsverzeichnis
Werbung
See
Symptom
Point to check
page
• The temperature
of the display panel
• The plasma display panel is lighting the
surface is high.
phosphors by the discharge of internal
radiation. In some cases, this may cause
the temperature
of the panel surface to
increase. Please note that this is not a
malfunction.
• There are locations on the screen that
• High-precision
technology is used to
are different from the periphery (*).
manufactue
the plasma display panel,
• Points that do not light, points with
However in some cases, there are minor
brightness different from that of the
defects in some parts of the screen. Please
periphery, points with color different
note that this is not a malfunction.
from thai of the periphery, etc.
• Vertical stripes appear, depending on the • The plasma display panel is lighting the
screen contents,
phosphors by the discharge of internal
radiation. Depending on the screen
contents, in rare cases this may cause
vertical stripes to appear because of failure
to light. Please note that this is not a
malfunction.
• Coarse horizontal stripes appear in FULL • Adjusting the phase will reduce the
display,
horizontal stripes.
_1"6_
(RGB inpul)
• The display dims to make the picture
• This condition may occur when the unit is
invisible during special playback of a
connected to a VCR with component
output,
VCR (FF, REW).
such as 480i, but it is not a failure. But when
it occurs, switch to composite output or Sl
(S2) output).
• Flickering in the form of horizontal lines
• If the direct frequency from the computer is
oscillating up and down.
below 85Hz, try a higher frequency (upper
limit 85Hz). There may be a slight
attenuation
of the current image.
• The fan motor is noisy.
• Use the fan that controls the temperature
in
the main body to lower the temperature of
this unit. If the ambient temperature is high,
the noise from the motor increases as the
rotation speed increases.This
is not a
malfunction.
• The top of the monitor heats up.
• When used for long periods of time, the top
of the monitor may heat up. This is not a
malfunction.
Werbung
Inhaltsverzeichnis
