Hitachi PD1 Handbuch Seite 57

• Approximately 1 sec. after adjustment is completed, the adjustments will be
recorded as shown in the table below.
Item Display Registration Reproduction
condition condition
Sound vo{utl_e
Sound balance
Treble
Bass
Mule voiume
Input status automatic
display
Line correction
Three-dimensional Y/C
separation
HD signal
Language selection
VOLUME
BALANCE
TREBLE
BASS
MUTELEVEL
AUTO FREQ.
LINE INTP.
3D COMB
One set can be recorded.
During normal signal
reception.
COMPONENT
LANGUAGE
One set can be recorded
Contrast CONTRAST during common RGB1,
Brightness BRIGHTNESS RGB2 input; one set of During normal signal
Color temperature COLOR SELECT two can be recorded
Gamma correction GAMMA during normal signal reception.
Input signal level VIDEO LEVEL reception with common
VIDEO 1, VIDEO 2 inpuh
Color COLOR
One set can be recorded
Tint TINT during common VIDEO 1, During normal signal
Sharpness SHARPNESS reception.
Video enhance VIDEO ENHANCE VIDEO 2 input.
Display area DISPLAY AREA
Display size DISPLAY SIZE
Horizonal position H.POSITION One group can be During recording and when
Vertical position V.POSITION recorded for each signal the same signal mode is
Dol clock frequency CLOCK mode. detected.
Dol clock phase PHASE
Verical size V. SIZE
• The previously recorded items will be lost.
• The signal mode can be identified by the horizontal/vertical sync frequency and the sync
signal polarity. Different signals with which all the elements are the same or similar will be
handled as the same signal.
• RGB 1 and RGB2 inputs have common elements that can be recorded for each signal mode.
Because of this, when the contents are recorded with RGB 1 (or RGB2), there may be loss
of adjustment during RGB2 (or RGBI) reception in the same signal mode.