Hitachi PD1 Handbuch Seite 58

• The on-screen display system shown to the right will be displayed when the
SELECT button is used to select DISPLAY
and moreover DISPLAY INIT is selected from
the On-screen Display System [1_. If the <3
INITIALIZE ?
key (select YES) of the SELECT button is YES '_" + NO
pressed at this time, the user adjustment vahles
in the table below for the signal currently being
received will be deleted and the factory settings
will be restored.
• Pressing the [1:> key (select NO) cancels deletion and returns the DISPLAY MENU.
DISPLAY menu item Display Application
Horizontal position H.POSITION RGB1, RGB2
Vertical position V.POSITION RGB1, RGB2, VIDEO1, VIDEO2
Dot clock frequency CLOCK RGB1, RGB2
Dot clock phase PHASE RGB1, RGB2
Vertical size V. SIZE VIDEO1, VIDEO2
1
• Changes in the signal status are displayed on the screen as they arise.
Status Action
Fhe input signal was
_witched or the
RECALL button was
_ressed after AUTO
=REQ was turned oil
_,sync signal could not
)e detected
the input signal does
lot meet display
)ecffications or erra_c
Display
I The input terminal and the
horizontal and vertical
frequencies are displayed in
a guidance image
, The guidance message
"POWER SAVE" is
displayed for about 5
seconds
, In the event of continued
absence of a sync signal,
the power indicating lamp
flickers and the monitor
enters power save mode
, The guidance message
"OUT OF FREQUENCY" is
displayed
• Check the power switch of
the PC and its status of
connection
• Check the input signal
specifica_ons once again
RGB
RGB1 [D-SUB]
H : 46 5kHz, V : 60 0Hz
VIDEO
VEDEO1
Either VIDEO or S VIDEO is
displayed on VIDE() inpm
POWER SAVE
OUTOFFREQUENCY
21