Hitachi PD1 Handbuch Seite 4

• Do not apply shock to the monitor.
• Do not use monitor if glass is broken or damaged.
If no picture, glass broken, smoke or something is smelling after applying shock to the
monitor, turn offthe monitor and disconnect the power plug from the mains immediately.
Then, call the service center.
If you continue to operate the monitor with such abnormal conditions, it may cause fire or
you may receive an electric shock.
• Do not disassemble or modify the monitor.
There is high voltage portion inside of the monitor. Disassembling or modification of the
monitor may cause fire or electric shock.
• Do not use the monitor in wet environment.
If you use the monitor in a wet place such as bath or shower room, it may cause fire or
electric shock. Using the monitor beside a window when snowing or raining or by a seaside
are not recommended.
• Do not damage or modify the power cord.
If you put something heavy on the power cord or pull, squeeze, heat the cord, it may be
damaged and it may cause fire or electric shock.
If the power cord is damaged, call service center.
WARNING/
Fire or electric shock may cause death or serious injury unless
I
you follow the instruction.
• The enclosed power cord must be used!
Failure to do so may cause electric shock hazard or fire hazard.
In USA/Canada, use a UL LIS'IED/CSA LABELLED or CERTIFIED power cord set
meeting the tbllowing specifications :
Rating: min. 125V, 10A, Length: max. 3.0m, Type: SV'I or SJ'I
Plug type: NEMA 5-15P figure, Parallel blade, Grounding type
In Europe or 200V area, a proper European standard approved power cord is to be used
with this monitor.
For a rated current up to 6 A, a type not lighter than H05VV-F 3G 0.75 mm 2 or H05VVH2-F
3G 0.75 mm 2 must be used.
• Use only the correct voltage power outlet with safety ground
connectiont
100 - 120 V fbr USA, Canada, etc.
200 - 240 V tbr Europe, etc.
(This monitor will automatically adjust to the input voltage 100 - 120 / 200 - 240V.)
• Be careful of power cord connection!
Befbre inserting the plug of the power cord into a socket of the correct voltage, check that
the connection portion of the power cord is clean (with no didst). Then, insert the plug of
power cord into the socket firmly, othel_vise it may cause electric shock or fire hazard.
• Do not touch the power plug when lightning is close to you.
You may receive an electric shock.