Hitachi PD1 Handbuch Seite 6

]/t_ You may have serious injm 7 or your property may be damaged
CAUTION
unless you tbllow the instruction below.
• Do not coil or wind the power cord.
This may cause excessive heat resulting in a fire.
• Caution for 200 - 240V operation only
This equipment relies on the protective devices in the building installation tbr short - circuit
and over- current protection. Refer to the following table for the suitable number and
location of the protective devices which should be provided in the building installation.
INFORMATIVE EXAMPLES OF PROTECTIVE DEVICES IN SINGLE - PHASE
EQUIPMENT OR SUB - ASSEMBLIES
Case A: Equipment to be connected to
POWER SYSTEMS with earthed neutral
retiably identified, except for Case C
below.
Case B: Equipment to be connected to
any supply, including IT POWER
SYSTEMS and supplies with reversible
plugs, except for Case C beIow.
Case C: Equipment to be connected to 3
- wire power systems wRh earthed
neutral refiably identified.
Protection
against
Earth faults
Overcurrent
Earth faults
Overcurrent
Earth faults
Overcurrent
Minimum number
of fuses or circuit
- breaker poles
1
1
2
1
2
2
Location
Phase conductor
Either of the two
conductors
Both conductors
Eitherofthetwo
conductors
Each phase
conductor
Each phase
conductor
Verify that the protective devices in the building installation meets the conditions
in the table prior to installing the equipment.
• Remove the power cord for complete isolation!
For complete isolation from the mains, remove the power cord from the monitor or from the
wall socket.