Power Status - Hitachi PD1 Handbuch

• To turn the monitor power ON, press the main power switch (@) on the monitor
main unit to ON, and then press the SUB POWER button or the (31 or I button on
the remote control.
• To turn the monitor power OFF, press the SUB POWER button or the OI or ©
button on the remote control, and then press the main power switch (©) on the
monitor main unit to OFF.
• During normal use, the main power switch (@) is set in the ON position, and the monitor
can then be turned ON/OFF using the SUB POWER button or the OI button on the
remote control.
Indicating lamp Power status Operating
Off Off When the main power switch O is set to
OFF.
When the main power switch (C)) is ON,
Off and the O button on the
Lights red (standby) remote control or the SUB POWER button
on the underside of the front of the frame
is OFF.
When the main power switch (C)) is ON,
Lights or blinks On and the I button on the remote control or
green the SUB POWER button on the underside
of the front of the frame is ON.
• When the indicating lamp blinks in green or the message
"POWER SAVE" or "OUT OF FREQUENCY" appears on
the screen, there is something unusual about the status of
reception. See "Symptoms That Seemingly Appear to be
Failures." _2_1
II
@ ain power
switch
/x
[L
dZ°w2
TIPS
• Avoid repeatedly turning the monitor on and off at short time
intervals. Failures might result from such operation.
• Turn off the main power switch (@) before leaving the monitor out
of use tbr an extended period of time.
• Ifa power failure occurs while the main unit is running, it would be
powered on upon recovery from the ti_ilure. Turn offthe unit main
power switch betbre leaving the main unit.
9