Hitachi PD1 Handbuch Seite 40

• No stand is provided
with this product. When installing the monitor, use the
oplional Desk-top Stand (CMPAD05), Wall Mount Unit (horizontal-mount
CMPAK04 or CMPAK05, vertical/horizontal-mount CMPAKI4), or Ceiling
Mount Unit (CMPAT04).
The Desk-top Stand has been used for the illustrations in this manual.
• Use one of the special mount units to install this product. A mount of insufficient
strength or inadequate design can cause overturning or dropping and result in fire
W3,RNING
electrical sbock o1" injury. Please note that our company assumes absolutely no
responsibility fbr personal injuries or property damage caused by use of other
mount units or improper installation.
• Installation of lbe wall mount unit and ceiling mount unit can be dangerous, so do not
attempt this work yourself Ask your dealer to provide the name of a qualified installer.
CAUTIONS
" In order to prevent an internal tenlperature b]crease, l_mintaillaspaceofl0cm(4
inches : For a desktop set-up) or more between the sides and other ol_iects such as
walls, etc., so that the ventilation holes are not blocked.*
/&
• Have this unit mounted in a stable place. Take measures to prevent it fi'om
/_!5 CAUTIONS
t umbling down to avoid possible physical injury.
Securing to a wall or pillar
l)Using a commercially available cord, chain and clamp, secure the set to a fi]l]a wall or
pillar.
I
Securing desktop
1)Using wood screws (two), fbsten the set to the clamping screw boles on the rear of the
stand as shown.
2)Using commercially available wood screws, secure the set firmly in position.
Using the optional vertical-mount unit (CMPAK14)
Using the optional wallm]ount unit (CMPAKI4) allows set to mount on wall surl_ces as
shown at right.
1 ) Make at [east fbur sets of commercial anchor bolts and screws availableto meet _arious kinds ot"
wails to mount on
2) Read tile instructions supplied with tile wall momlt mitt careNHy to optimally locate tile plasma
display on a wall surfhce
3) Prepare tbe wall surfhcetbr anchoring and drilling as needed, as shown in tbe sketches
• Make sure that an adequate wall sm'fhcestrength and a screw holding strength are available
• I- p[_er eft vet tical mou_ting
• Hor_zonta_ mo_ntin 9
Plasma _is_lay outl_n_
plasma _isplay outl_n_
Illl01
Wal_
_rface
A_ch_r bdt
F_o_dto 25 mm
(1 inca)
Horiz_n_almou_tin_
_-p_er _dt wmca] m_nti_g
CAUTION
' The mounted unit should
have the indicating lalnp
at its bottoln. Otherwise,
an elevated internal
temperature rise could
cause the unit to fhil or
fire.
3