Prevention Of An Obstacle To Radio Receivers - Hitachi PD1 Handbuch

SAFETY GUIDELINES(continued)

• Prevention of an obstacle to Radio receivers

This monitor has been designed pursuant to the FCC class B Rules (see page VII). This is to
prevent a problem to Radio receivers.
If this monitor cause a problem to Radio receivers, then take the following steps:
- Keep the monitor away from Radio.
- Adjust Radio antennas in order for the monitor not to receive interference.
- The antenna cable of Radio should be kept away from the monitor.
- Use a coaxial cable for antenna.
You can check if this monitor influences Radio receivers by turning off all other equipment
other than the monitor.
If you find a problem receiving Radio when using the monitor, check the instructions
mentioned above.
• Precautions for the monitor
- Confirm the connector is fixed tightly when the signal cable is connected.
Also confirm the screws on the connector are tightened.
- Plug the power cord of the monitor into a different socket from that for other equipment,
such as Radio etc..
- Use a plug with ground terminal and make sure that it connects to the ground.
• Precaution during transportation
Please pay attention when you transport this monitor because it is heavy.
Furthermore, use the original carton box and its packaging materials when the monitor is
transported.
Failure to transport the monitor in any carton except the original carton may result in damage
to the monitor.
Save the original carton box and all packing material.
VI