Contrast Adjustment; Size Selection; Input Signal Status Display; On-Screen Display System - Hitachi PD1 Handbuch

Contrast Adjustment

I While the on-screen display system
controller SELECT button
• When you press these buttons, the status of
contrast adjustment and the input horizontal
(H) and vertical (V) frequencies of the input
signal will be displayed in a guidance image.
(For RGB input only)
• While the guidance is on display, press the
key to narrow the difference between darkness
and brightness.
• While the guidance is on display, press the
key to widen the difference between darkness
and brightness.
• You can also adjust the contrast setting via the

on-screen display system

• The contrast adjustment mode will exit when
no keys are entered for 5 seconds. (The
adjustment status guidance will disappear
automatically.)

Size Selection

I Each press on the SIZE button on the remote control switches the display size of
the screen (or the display area) in the following order. The selected mode is
displayed in the lower part of the screen.
•RGB signal input
NORMAL FULL
•VIDEO signal input
4:3 PANORAM.
FULL MOVIE2
• Depending on the signal type, sometimes it may not be possible to change screen size.
Sometimes certain sizes may be unavailable.

Input Signal Status Display

I Press the remote controller RECALL button to
display the status of input signals on the screen.
I Press the remote controller RECALL button
once again to exit the screen display.
• The Menu will clear 5 seconds later.
, is not on display, press the remote
12
or to adjust the contrast.
.
13
ZOOM
MOVIE1
VIDEO
Remote
controller
RGB
H :
Input horizontal
frequency
Adjustment status guidance
Remote
controller
SIZE
16
15
VIDEO
VIDEO2 [COMPONENT]
Remote
controller
RECALL
RGB
H : 46.5kHz, V : 60.0Hz
Input horizontal
frequency
CONTRAST : 100
Contrast setting
CONTRAST : 100
** * ** *
. kHz, V : . Hz
Input vertical
frequency
FULL
Input terminal name
RGB1 [D-SUB]
Input vertical
frequency
11