Handling The Remote Controller; Loading Batteries - Hitachi PD1 Handbuch

INSTALLATION INSTRUCTIONS (continued)

Handling the Remote Controller

Loading Batteries

1) Open the battery cover.
• Slide the battery cover towards the arrow mark while
pressing it.
2) Load batteries.
• Load two Size AA batteries included observing the
correct polarities.
3) Close the battery cover.
• Slide back the battery cover towards the arrow mark.
Handling the Remote Controller
• Use the remote controller within about 5 m from front of the
unit's remote-control sensor and within 30 degrees on both
sides.
CAUTIONS
TIPS
8
• Do not use new and old batteries together. The batteries could
explode or leak, resulting in fires, physical injury, or stains.
• When loading batteries, observe their correct polarities as marked on
the product. If loaded in the wrong direction, the batteries could
explode or leak, resulting in fires, physical injury, or stains.
• Do not drop or impact the remote controller.
• Do not splash the remote controller with water or put it on a wet
object to avoid possible failures.
• Before leaving the remote controller out of use for an extended
period of time, remove the batteries from it.
• If the remote controller begins to lack responsiveness, replace the
batteries.
• Strong light such as direct sunlight impinging on the photoreceptor
of the remote control can cause operational failure. Position this unit
to avoid direct contact with such light.
With in 30 With in 30
degrees degrees
About 3m About 3m
About 5m
SIZE
VIDEO 1 VIDEO 2 RGB 1 RGB 2
VOLUME+
MUTE VOLUME-
MENU RECALL