Reset (Settings Initialization); Signal Check - Hitachi PD1 Handbuch

Reset (Settings Initialization)

I The on-screen display system shown to the right will be displayed when the
SELECT button is used to select DISPLAY
and moreover DISPLAY INIT is selected from
the On-screen Display System
key (select YES) of the SELECT button is
pressed at this time, the user adjustment values
in the table below for the signal currently being
received will be deleted and the factory settings
will be restored.
• Pressing the key (select NO) cancels deletion and returns the DISPLAY MENU.
DISPLAY menu item
Horizontal position
Vertical position
Dot clock frequency
Dot clock phase
Vertical size

Signal Check

I Changes in the signal status are displayed on the screen as they arise.
Status
The input signal was
• The input terminal and the
switched or the
horizontal and vertical
RECALL button was
frequencies are displayed in
pressed after AUTO
a guidance image.
FREQ was turned on.
• The guidance message
"POWER SAVE" is
displayed for about 5
seconds.
A sync signal could not
• In the event of continued
be detected.
absence of a sync signal,
the power indicating lamp
flickers and the monitor
enters power save mode.
The input signal does • The guidance message
not meet display "OUT OF FREQUENCY" is
specifications or erratic. displayed.
12 . If the
Display
H.POSITION
V.POSITION
CLOCK
PHASE
V. SIZE
Display
• Check the power switch of
the PC and its status of
connection.
• Check the input signal
specifications once again.
RGB1, RGB2, VIDEO1, VIDEO2
RGB
Action
-
VIDEO
Either VIDEO or S VIDEO is
displayed on VIDEO input.
~
27
30
Application
RGB1, RGB2
RGB1, RGB2
RGB1, RGB2
VIDEO1, VIDEO2
RGB1 [D-SUB]
H : 46.5kHz, V : 60.0Hz
VIDEO1
POWER SAVE
OUT OF FREQUENCY
21