Hitachi PD1 Handbuch Seite 68

PRODUCT SPECIFICATIONS (continued)
Recommended Signal List (continued)
Composite / S input (VIDEO 1 input)
No.
Signal Name
NTSC
1 NTSC-4.43
M-PAL
PAL
2 N-PAL
SECAM
Component input (VIDEO 1 input)
No.
Signal Name
1 480/60i
2 575/50i
3 480/60p
4 720/60p
5 1080/60i
6 1035/60i
• The type of video board or connecting cable used may not allow for correct displays adjustment of
H.POSITION, V.POSITION, CLOCK and PHASE.
• The monitor may fail to display an animation image correctly when a signal having a vertical frequency
of 85Hz or higher is input to it.
• The monitor differentiates the signal modes according to the horizontal and vertical frequencies and the
horizontal and vertical sync signal polarities. Note that different signals having all these elements alike
may be handled as the same signal.
• Displaying images with more than 512 lines of vertical resolution at Full diplay (compressed display) can
result in the interpolation of stripes.
• Use of this monitor with the input signal timings specified below is recommended. A predefined setting
may not be reproduced correctly with an extremely long front porch or back porch or with an extremely
short data display time.
Horizontal frequency
24 kHz to 52 kHz
Horizontal
timing
Horizontal frequency
52 kHz to 107 kHz
Vertical timing
30
Signal mode
Vertical
Resolution
frequency (Hz)
525 59.94
625 50.00
Signal mode
Vertical
Resolution
frequency (Hz)
480 59.94
575 50.00
480 59.94
720 59.94
1080 60.00
1035 60.00
Front porch
0.2 µs or more
0.2 µs or more
9 µs or more
Horizontal
frequency (kHz) frequency (MHz)
15.73
15.63
Horizontal
frequency (kHz) frequency (MHz)
15.73
15.63
31.47
44.96
33.75
33.75
Sync width Back porch
1.0-4.0 µs 1.2 µs or more
0.8-3.0 µs 1.1 µs or more
25 µs or more 400 µs or more
Dot clock
Remarks
-
-
Dot clock
Remarks
-
-
-
-
-
-
Blanking width
3.5 µs or more
2.3 µs or more
450 µs or more