Saving And Recalling Adjustments And Settings; Saving Adjustments And Settings; Recalling Adjustments And Settings - Sony HKDV-900 Bedienungsanleitung

Saving and Recalling Adjustments and Settings

Saving and Recalling Adjustments and Settings
You can save up to 99 sets of settings in memory and
recall them as needed. Each set consists of the settings
for each output signal and the system settings.

Saving adjustments and settings

2
1
Press the STORE button.
The MEMORY ADDR. indicator flashes.
When DIP switch S100-2 on the internal board is
set to the ON position, the memory address is
displayed.
2
Check the memory address shown by the
MEMORY ADDR. indicator, and if necessary
change it.
The addresses are in the range 01 to 99.
Press the + button to increase the address, and the
– button to decrease the address.
3
Press the STORE button once again.
This saves the adjustments and the settings, and the
flashing is stopped.
When DIP switch S100-2 on the internal board is
set to the ON position, the MEMORY ADDR.
indicator returns to showing adjustment and setting
values.
To cancel the operation
Press the CANCEL button.
12(GB)
1,3
Recalling adjustments and
settings
2
1
Press the LOAD button.
The CONTROL SELECT buttons (1 to 4) and the
MEMORY ADDR. indicator flash.
When DIP switch S100-2 on the internal board is
set to the ON position, the memory address is
displayed.
2
Press one of the CONTROL SELECT buttons to
select the device whose output video signal is to be
adjusted.
3
Change the memory address displayed in the
MEMORY ADDR. indicator to the desired address
to be recalled.
Press the + button to increase the address, and the
– button to decrease the address.
4
Press the LOAD button once again.
This recalls the adjustments and the settings, and
the flashing is stopped.
When DIP switch S100-2 on the internal board is
set to the ON position, the MEMORY ADDR.
indicator returns to showing adjustment and setting
values.
To cancel the operation
Press the CANCEL button.
If the device connected at the time the adjustments
and the settings are saved and the device currently
being connected are different, or when you recall a
memory address to which no adjustments and the
settings are saved, an error indication "Er" appears
in the MEMORY ADDR. indicator. To turn off
the indication, press the CANCEL button.
1,4
3